If you possess the files to be sent, in addition to the directory for storing these on your virtual machine ready, you may simply go ahead and send the file by using the following command:

Here, you must revisit the sender system now that you are aware of the IP of the receiver. The IP address exhibited on inet address: is the one your machine would have in your internal network, and it will be the one you are going to access the machine under. TX packets:39 errors:0 dropped:0 overruns:0 carrier:0 RX packets:39 errors:0 dropped:0 overruns:0 frame:0 TX packets:128835 errors:0 dropped:0 overruns:0 carrier:0

RX packets:234392 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 ~ $ ifconfigĮth0 Link encap:Ethernet HWaddr f4:6d:04:94:8f:17 The ifconfig will throw up a few blocks, like the one titled eth0. Once begun, you must open a terminal and key in the following: Now, you can run your virtual machine.ġ.3 Initiating File Copy between Linux Servers Using SCP You must select Bridged Adapter from the ' Attached to' dropdown menu.Ħ. Please select the correct Adapter tab (it will be the first one in case you have not made any changes so far)ĥ. Please select the virtual machine where your target system is running.Ĥ. It also allows you to copy files from one remote server to another remote server, without passing traffic through your PC.ġ.2 Configuring the System of the Virtual MachineĪt the outset, for sending files to the virtual machines, you would require a specific set of configuration, as explained below:Ģ. SCP is used to copy files to/from a remote server. The SCP command line is commonly used to copy files over SSH, and between popular Operating systems like Linux, Mac and Windows in a secure fashion.

Scp on mac command line